# FAQ: Have A Corner Kitchen Cabinet Not To The Ceiling How To Find The Angle For Crown Molding?

Contents

- 1 What is the angle for crown molding on a corner cabinet?
- 2 How do I know the angle of my crown molding?
- 3 How do you measure for crown molding on kitchen cabinets?
- 4 How do you cut crown molding on a corner cabinet?
- 5 What angle is corner?
- 6 What is a 38 degree spring angle?
- 7 How do you fill the gap between kitchen cabinets and ceiling?
- 8 Can you add crown molding to cabinets?
- 9 How do you miter crown molding at any angle?

## What is the angle for crown molding on a corner cabinet?

Measuring Around Corner Cabinets Corner cabinets meet the rest of the cabinetry at an approximate 45 degree angle. Since the bisection may not be an exact 22-1/2 degrees, employ a technique similar to the one used to bisect outside angles. Overlap two boards against the cabinet face near the ceiling.

## How do I know the angle of my crown molding?

To find out what the spring angle is, set the crown molding into the crotch of a framing square and check where the ends align. if both numbers are the same, it is 45/45 crown. If the numbers are different, such as three inches on the wall and two inches on the ceiling, it is 52/38 crown.

## How do you measure for crown molding on kitchen cabinets?

Measure a piece of crown molding equal to the length of the cabinet. Place your tape measure on the edge of the crown and extend it to the length of one cabinet side. Use a pencil to mark the exact spot that needs to be cut. Repeat for each cabinet side.

## How do you cut crown molding on a corner cabinet?

To cut crown molding inside corners, start by measuring the angle of the corner using an adjustable protractor, and setting a compound miter saw to the correct angles. Next, place the piece of crown molding in the jig and the bed of your saw to cut the right inside corner.

## What angle is corner?

The formula involves dividing 360 by the number of sides to calculate the corner angle. Then divide it by two to get the miter angle. If you’re making a five-sided project with all sides equal, you divide 360 by five to get 72 degrees. So each joint or corner forms a 72-degree angle.

## What is a 38 degree spring angle?

Read Angle Here To find the crown spring angle, subtract the measured angle from 180°. The Crown Spring Angle = 180° – 142° = 38°.

## How do you fill the gap between kitchen cabinets and ceiling?

You can build the cabinets to the ceiling (most expensive option), keep the area open (no cost!), build a soffit to match the cabinets, or add a drywall soffit.

## Can you add crown molding to cabinets?

Provide a nailing surface for crown moulding by attaching solid wood mounting strips to the top edges of the cabinets. Cut strips of straight 3/4-in x 1-1/2-in wood to fit the front and sides of each cabinet. Then apply wood glue to each strip, nail it in place, and let dry.

## How do you miter crown molding at any angle?

How To Cut Crown Molding Flat on a Miter Saw

- Set the miter angle to 31.6 degrees. On most saws, “31.6” is specially marked.
- Set the bevel to 33.9 degrees. Once again, this adjustment will have a special marking on most saws.
- Lay the crown flat and cut.
- Reverse the settings and repeat.